Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2020G90 3.3T PREMIUM, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESSMART JUNCTION BLOCK DIAGNOSISDTC B2522-00: TURN SIGNAL LH FRONT SHORT TO GROUNDVERIFICATION OF REPAIRVERIFICATION OF VEHICLE REPAIR
2020 Genesis G90 3.3T Premium, AWD
Verification Of Vehicle Repair
2020 Genesis G90 3.3T Premium, AWDSECTION Verification Of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
- Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
- Erase the DTCs and Operate the vehicle within DTC Enable conditions in General information.
- Is any DTC output again?
YES
- Go to the applicable troubleshooting procedure.
NO
- System performing to specification at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.