Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- NOTE:
Left side shown, right side similar.
Connect the electrical connector.
- Radio Front Speaker (2) - Install
- Radio Front Speaker Bolt (1) - Install and tighten [2x] - Fastener Specifications
{ If equipped } Connect the electrical connector.
- Instrument Panel Extension (1) - Install
- NOTE:
Left side shown, right side similar.
Ensure tabs is fully seated in the I/P upper trim panel prior to engaging upper clip.
- Windshield Garnish Molding- Left Side and Right Side (3) - Install [2x]
- Windshield Pillar Assist Handle Bolt- Left Side and Right Side (2) - Install and tighten [4x] - Fastener Specifications
- Windshield Pillar Assist Handle Cover - Left Side and Right Side (1) - Install [4x]
- Enable the SIR System. SIR Disabling and Enabling
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.