Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2024SIERRA 2500 HD DENALI ULTIMATEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK69 TRANSFER CASE CONTROL MODULE: PROGRAMMING AND SETUP (NQF)PROGRAMMING AN EXISTING OR NEW CONTROL MODULE
2024 GMC Sierra 2500 HD Denali Ultimate
Programming an Existing or New Control Module
2024 GMC Sierra 2500 HD Denali UltimateSECTION Programming an Existing or New Control Module
To program an existing or new control module, perform the following procedure:
- Ignition - On / Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: K69 Transfer Case Control Module
- Perform the SPS function: K69 Transfer Case Control Module - Programming
- Perform the SPS function: K69 Transfer Case Control Module - Setup
- Clear DTCs.
- Perform the scan tool Transfer Case Range Actuator Dual End Stop Learn.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.