Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Video Display (2) - Install
- Front Seat Nut (1) - Install and tighten [ 4x ] - Fastener Specifications
- NOTE:
Quantity of electrical connectors will very from left side to right side.
Connect the electrical connectors. (3) - Install
- Push the connector position assurance (CPA) (2) upwards to lock electrical connector (3).
- Secure the clip (1) to secure the wiring harness (4).
Front Seat Back Upper Cover-Lower (2) - Install
- Front Seat Bolt (1) - Install and tighten - Fastener Specifications
Front Seat Back Opening Bezel (1) - Install
Front Seat Back Upper Cover (1) - Install
Front Seat Head Restraint Guide Bezel (1) - Install [ 2x ]
- Front Seat Head Restraint (3) - Install
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.