Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Radio (1) - Install
- Secure the retaining tabs.
- Connect the electrical connectors.
Multifunction Power Supply Converter Bracket (2) - Install
- Multifunction Power Supply Converter Nut (1) - Install and tighten [ 2x ] - Fastener Specifications
Multifunction Power Supply Converter (1) - Install
Electrical Connector (1) - Connect
- Retaining Tab (2) - Engage
Instrument Panel Lower Trim Panel Insulator (1) - Install
Instrument Panel Lower Insulator Retainer (1) - Install [ 3x ]
- Perform the necessary programming and setup procedure: Control Module References
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.