Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Connect the electrical connectors.
- Radio Control (1) - Install
- CAUTION:
Refer to Fastener Caution .
Radio Control Bolt (1) - Install and tighten [ 5x ] - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Accessory Bezel (2) - Install
- Instrument Panel Accessory Bezel Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications
Slide the front floor console (1) back into the instrument panel.
Front Floor Console Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
- Front Floor Console Retainer Bolt (2) - Install and tighten - Fastener Specifications
Front Floor Console Retainer Bolt (1) - Install and tighten - Fastener Specifications
- Front Floor Console Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
Front Floor Console Bolt Access Hole Cover (1) - Install
Front Floor Console Extension Panel (1) - Install
Instrument Panel Lower Center Trim Plate Applique (2) - Install
- Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten - Fastener Specifications
Front Floor Console Applique (1) - Install
Front Floor Console Lower Applique (1) - Install
Connect the electrical connectors.
- Instrument Panel Transmission Shift Opening Cover (2) - Install
- Instrument Panel Center Trim Panel Bolt (1) - Install and tighten [ 6x ] - Fastener Specifications
Instrument Panel Lower Center Trim Plate Applique (2) - Install
- Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten [ 6x ] - Fastener Specifications
Instrument Panel Center Trim Plate Applique (1) - Install
Instrument Panel Trim Plate Applique (1) - Install
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Front Floor Console Bolt Access Hole Cover (1) - Install
Front Floor Console Extension Panel (3) - Install
- Front Floor Console Extension Bolt (2) - Install and tighten - Fastener Specifications
- Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Install
Front Floor Console Applique (1) - Install
Front Floor Console Lower Applique (1) - Install
Front Seat (2) - Install [ 2x ] - Front Seat Removal and Installation
Refer to Fastener Caution .
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.