Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2021SIERRA 2500 HD AT4, 6.6L ENG VIN 7REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESS SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSREAR GATE MODULE REPLACEMENT
2021 GMC Sierra 2500 HD AT4, 6.6L Eng VIN 7
Rear Gate Module Replacement
2021 GMC Sierra 2500 HD AT4, 6.6L Eng VIN 7SECTION Rear Gate Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Pickup Box Endgate Access Hole Cover Panel Replacement (With Step)Pickup Box Endgate Access Hole Cover Panel Replacement (Without Step) |
|
| 1 | Latch Control Module Bracket Bolt [ 3x ]
CAUTION:
Tighten 2.5 N.m (22 lb in) |
| 2 | Accessory and Liftgate Control Module Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.