K115 Reductant Control Module X2

2020 GMC Savana 3500 LS, Van Passenger, 6.0L Eng VIN B, Gas/EthanolSECTION K115 Reductant Control Module X2
GM2871898Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type: Reductant Tank
  • OEM Connector: 13650143
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 20-Way F 1.5 Series, Sealed (BK)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool Service Terminal Tray Name Core Crimp Insulation Crimp
I Not Required Not Available No Tool Required Not Required Not Required Not Required Not Required
Pin Size Color Circuit Function Terminal Type ID Option
1 - OG 3103 Diesel Exhaust Fluid Smart Pump Control I -
2 - GN 3875 Diesel Exhaust Fluid Smart Pump Supply Voltage Phase 2 I -
3 - BU 3876 Diesel Exhaust Fluid Smart Pump Supply Voltage Phase 3 I -
4 - VT 4318 Diesel Exhaust Fluid Tank Heater Low Control I -
5 - BK 3104 Diesel Exhaust Fluid Smart Pump Low Reference I -
6 - OG 7285 Diesel Exhaust Fluid Liquid Quality Temperature Sensor Low Reference I -
7 - YE 3922 - I -
8 - - - Not Occupied - -
9 - OG 3244 Diesel Exhaust Fluid Tank Temperature Sensor Signal I -
10 - GN 3245 Diesel Exhaust Fluid Tank Temperature Sensor Feedback Signal I -
11 - YE 3921 - I -
12 - BU 3106 Diesel Exhaust Fluid Pressure Sensor 5 Volt Reference I -
13 - GY 3108 Diesel Exhaust Fluid Pressure Sensor Signal I -
14 - YE 3107 Diesel Exhaust Fluid Pressure Sensor Low Reference I -
15 - VT 6136 Control I -
16 - BU 3028 Diesel Exhaust Fluid Tank Level Sensor Signal I -
17 - VT 3029 Diesel Exhaust Fluid Tank Level Sensor Low Reference I -
18 - GN 7487 Sensor Signal I -
19 - YE 53 Diesel Exhaust Fluid Quality Signal I -
20 - VT 4319 Diesel Exhaust Fluid Line Heater Low Control I -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.