Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Install the front side door latch (1) to the front side door window module support bracket (2).
Front Side Door Latch (2) - Install
- Front Side Door Latch Bolt (1) - Install and tighten 10 N.m (88 lb in)
Front Side Door Wiring Harness (1) - Install
Front Side Door Inside Handle Rod (1) - Install
- Front Side Door Lock Rod (2) - Install
Front Side Door Outside Handle Rod (1) - Install
- Front Side Door Lock Cylinder Rod - Install
- Front Side Door Window Channel Replacement - Lower Rear - Install - Front Side Door Window Channel Replacement - Lower Rear
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.