Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2020 GMC Acadia SLSECTION Removal Procedure
WARNING: This page is about a different car, the 2023 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the K47 Rear Differential Clutch Control Module for removal using the SPS programming support tool. Control Module References
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the four control module bracket bolts (1).
Disconnect the connector (1 and 2) from the control module.
- Remove Wiring Harness Retainer from Clutch Control Module.
Remove the clutch control module (1).
NOTE:
The rear differential clutch control module can now be removed and replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.