Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Assembly Procedure
2020 GMC Acadia SLSECTION Assembly Procedure
WARNING: This page is about a different car, the 2021 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Front Suspension Strut Bumper (1) - Install
- Front Strut Boot (2) - Install
- Front Coil Spring Insulator (2) - Install
- Front Strut Mount (1) - Install
- Install the front coil spring (2) and the associated components to the CH-48845
Strut Spring Compressor (1).
- Using the CH-48845 Strut Spring Compressor (1), apply tension on the front coil spring (2).
- Front Coil Spring Lower Insulator (2) - Install
- Front Suspension Strut (3) - Install
NOTE:
Support the front suspension strut until the front suspension strut nut is loosely installed.
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.