Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2020ACADIA SLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (FRAME AND UNDERBODY)SPECIFICATIONSFASTENER SPECIFICATIONS
2020 GMC Acadia SL
Fastener Specifications
2020 GMC Acadia SLSECTION Fastener Specifications
WARNING: This page is about a different car, the 2019 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Drivetrain and Front Suspension Cradle Front Bolt | |
|
160 N.m (118 lb ft) |
|
60 - 75 Degrees |
| Drivetrain and Front Suspension Cradle Rear Bolt | |
|
160 N.m (118 lb ft) |
|
60 - 75 Degrees |
| Front Cradle Brace Bolt | |
|
58 N.m (43 lb ft) |
|
25 - 40 Degrees |
| Rear Suspension Cradle Bolt | |
|
160 N.m (118 lb ft) |
|
60 - 75 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Compartment Air Deflector Fastener | 2.5 N.m (22 lb in) |
| Front Compartment Splash Shield Bolt | 2.5 N.m (22 lb in) |
| Front Cradle Mount Bolt Bracket Bolt | 58 N.m (43 lb ft) |
| Front Tire Front Air Deflector Fastener | 2.5 N.m (22 lb in) |
| Front Wheelhouse Liner Bolt | 2.5 N.m (22 lb in) |
| Rear Cradle Mount Bolt Bracket Bolt | 58 N.m (43 lb ft) |
| Rear Tire Front Air Deflector Fastener | 2.5 N.m (22 lb in) |
| Rear Wheelhouse Liner Bolt | 2.5 N.m (22 lb in) |
| Trailer Hitch Support Bracket Nut - Rear | 58 N.m (43 lb ft) |
| Trailer Hitch Support Bracket Bolt - Underside | 100 N.m (74 lb ft) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.