Parking Assist Control Module Replacement

2020 GMC Acadia SLSECTION Parking Assist Control Module Replacement
WARNING: This page is about a different car, the 2019 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
GM4424522Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Quarter Lower Rear Trim Panel Replacement (Left Side with 5 Passenger Seat) , or Quarter Lower Rear Trim Panel Replacement (Left Side with 7 Passenger Seat)
1 Parking Assist Alarm Control Module Nut [2x]
Tighten 
4.5 N.m (40 lb in)
2 Parking Assist Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Perform the necessary programming and setup procedure: Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.