Sunroof Window Height and Opening Fit Adjustment

2020 GMC Acadia SLSECTION Sunroof Window Height and Opening Fit Adjustment
WARNING: This page is about a different car, the 2019 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
GM4677617Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Sunroof Window Screw [4x]

Procedure

  1. Cycle the sunroof window from full open to closed position.
  2. Loosen the adjusting screws on the sunroof window.
  3. Adjust the front of the sunroof window to window to 0-1 mm (0.00-0.04 in) below the top surface of the roof panel.
  4. Adjust the rear center line of the sunroof window to 0-1 mm (0.00-0.04 in) above the top surface of the roof panel.
  5. Cycle the sunroof window through all positions.
  6. Inspect the sunroof window adjustment. Adjust if necessary.

TightenΒ 
6N.m (53 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.