Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Video Processing Control Module Calibration (with UV2): Notes
- The surround vision camera system image will be slightly distorted at all times, the camera (s) lens is a fish-eye lens meant to capture as much range as possible.
- A Video Processing Control Module that is not calibrated adequately will display an hour-glass icon on the surround vision camera system image screen. Once calibration is attained, the hour-glass will automatically disappear.
The calibration procedure is needed to have the Video Processing Control Module learn new cameras and their positions. The calibration is performed automatically by the Video Processing Control Module.
If any one of the cameras is replaced on the Surround Vision Camera System, the camera image needs to be calibrated to the system. For this reason, the Video Processing Control Module performs a calibration during its power up and initialization during each ignition cycle in order to maximize the surround vision image quality.
A new Video Processing Control Module will have built-in default values for camera learn. However, the Video Processing Control Module will automatically calibrate in order adapt to the vehicle.
To allow the Video Processing Control Module to complete calibration, drive the vehicle. Driving the vehicle in the conditions listed below will reduce calibration time.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.