SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2020ACADIA SLREPAIR AND DIAGNOSISBODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSFRAME AND UNDERBODYREPAIR INSTRUCTIONSFRONT COMPARTMENT SPLASH SHIELD REPLACEMENT
2020 GMC Acadia SL

Front Compartment Splash Shield Replacement

2020 GMC Acadia SLSECTION Front Compartment Splash Shield Replacement
GM4283490Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
  2. Disconnect the front suspension 4 corner leveling system position sensor electrical connector and the wire harness retaining clips at splash shield, if equipped. Front Suspension 4 Corner Leveling System Position Sensor Replacement
1 Front Compartment Splash Shield Bolt [4x]
CAUTION:

Refer to Fastener Caution


Tighten 
2.5 N.m (22 lb in)
2 Front Compartment Splash Shield
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.