Error Codes during alignment

2019 GMC Yukon XL Denali, RWDSECTION Error Codes during alignment
Error Code Cause Possible Repair
0101 Front Camera
0103 Front Camera
0201 Right Camera
0203 Right Camera
0301 Rear Camera
0303 Rear Camera
0401 Left Camera
0403 Left Camera
Lighting Issue, Obstructed View of Target, Target Position out of Range, Poor Camera installation Correct Lighting, Reposition Target, Verify Camera correctly installed and clean.
0102 Front
0202 Right
0302 Rear
0402 Left
Lighting Issue, Obstructed View of Target, Target Position out of Range Correct Lighting, Reposition Target, Verify Camera is clean.
0104 Front
0204 Right
0304 Rear
0404 Left
Camera Position incorrect Correct camera position
0120 Front
0220 Right
0320 Rear
0420 Left
NTSC error detected Verify camera electrical connection
FFF0 Passenger Door
FFF1 Left Rear Door
FFF2 Right Rear Door
FFF3 Driver Door
FFF4 Trunk
FFF5 Hood
FFF6 Liftglass
Hood, Door, Liftgate, Trunk or other part of car OPEN Close all doors, Hood, Liftgate, and Trunk
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.