Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2019ACADIA SLE, 3.6L ENG VIN S, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (ENGINE CONTROLS AND FUEL - 2.5L (LCV) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWD
Installation Procedure
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWDSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Throttle Body Seal (2) - Install
- Throttle Body (1) - Install
- CAUTION:
Refer to Fastener Caution .
Throttle Body Bolt (1) - Install and tighten [4x] 10 N.m (89 lb in)
Electrical Connector (1) - Connect
- Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement
- Perform throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation Reset
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.