Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2019ACADIA SLE, 3.6L ENG VIN S, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (ENGINE CONTROLS AND FUEL - 2.5L (LCV) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSOIL PUMP FLOW CONTROL VALVE REPLACEMENT
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWD
Oil Pump Flow Control Valve Replacement
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWDSECTION Oil Pump Flow Control Valve Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Oil Pump Flow Control Valve Heat Shield Replacement |
|
| 1 | Oil Pump Flow Control Solenoid Valve Electrical Connector |
| 2 | Oil Pump Flow Control Valve Fastener
CAUTION:
Refer to Fastener Caution . Tighten 10 N.m (89 lb in) |
| 3 | Oil Pump Flow Control Valve Procedure Install a NEW O-ring seal. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.