Installation Procedure

2019 GMC Acadia SLE, 3.6L Eng VIN S, FWDSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
  1. GM4292621Courtesy of GENERAL MOTORS COMPANY

    O-Ring (2) - Install NEW

  2. Fuel Tank Fuel Pump Module (1) - Install
  3. GM4292619Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Lock Ring (1) - Install - CH 45722Β  Fuel Sender Lock Ring Wrench

  4. GM4292617Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Fuel Feed Hose (3) - Connect [2x] - Plastic Collar Quick Connect Fitting ServiceΒ 

  5. Evaporative Emission Canister Vent Hose (2) - Connect - Plastic Collar Quick Connect Fitting ServiceΒ 
  6. Electrical Connector (1) - Connect [3x]
  7. Fuel Tank - Install - Fuel Tank Replacement (FWD)Β 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.