Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2019ACADIA SLE, 3.6L ENG VIN S, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (ENGINE CONTROLS AND FUEL - 2.5L (LCV) - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSENGINE OIL PRESSURE SENSOR REPLACEMENTREMOVAL PROCEDURE
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWD
Removal Procedure
2019 GMC Acadia SLE, 3.6L Eng VIN S, FWDSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the right front tire and wheel assembly. Tire and Wheel Removal and Installation
Electrical Connector (1) - Disconnect
Battery Negative Cable Ground Stud (1) - Remove
- Battery Cable (2) - Reposition
Engine Oil Pressure Sensor (1) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.