Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2016SIERRA 3500 HD SLE, 4D CAB CHASSIS, 6.6L ENG VIN 8, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B1008: VEHICLE DIRECTION CAMERA INDICATORCIRCUIT/SYSTEM VERIFICATION
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WD
Circuit/System Verification
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WDSECTION Circuit/System Verification
- Ignition ON.
- Verify that DTC B101E 42 is not set.
- If DTC is set
Perform the Front View Camera Module Programming and Setup procedure.
- If the DTC is not set
- If DTC is set
- Verify that DTC B1008 is not set.
- If DTC is set
- Calibrate the front camera module. Refer to Front View Camera Module Calibration .
- Verify the DTC does not set.
- If the DTC sets, replace the frontview camera module.
- If the DTC does not set
- All OK.
- If the DTC is not set
- All OK.
NOTE:
Do not diagnose this DTC if set in history
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.