Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2016SIERRA 3500 HD SLE, 4D CAB CHASSIS, 6.6L ENG VIN 8, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMREPAIR INSTRUCTIONSFRONT PARKING ASSIST ALARM SENSOR REPLACEMENT (GMC OUTER)REMOVAL PROCEDURE
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WD
Removal Procedure
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WDSECTION Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the electrical connector from the front parking assist alarm sensor.
- Lift the locking tabs on the bracket and remove the front parking assist alarm sensor (1).
NOTE:
The front parking assist alarm sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.