Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The frontview camera module monitors the lane departure warning switch signal circuit. The frontview camera module applies voltage and monitors the switch signal circuit. The lane departure warning switch is normally open switch. With the switches open, voltage seen at the frontview camera module is high. When a switch is pressed, the signal circuit is pulled to ground and the voltage seen by the frontview camera module is low. The frontview camera module will respond to this by activating or deactivating the lane departure warning feature.
When the lane departure warning is enabled, the frontview camera module will illuminate the indicator on the switch. The indicator receives voltage through a high control circuit from the body control module (BCM) and is controlled through a low control circuit by the frontview camera module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.