Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2016SIERRA 3500 HD SLE, 4D CAB CHASSIS, 6.6L ENG VIN 8, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESLANE DEPARTURE WARNING SYSTEM MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WD
Circuit/System Verification
2016 GMC Sierra 3500 HD SLE, 4D Cab Chassis, 6.6L Eng VIN 8, 4WDSECTION Circuit/System Verification
- Ignition ON.
- Verify the scan tool Frontview Camera System Status parameter is Normal.
- If the parameter is Undefined or Malfunction
Refer to Diagnostic Aids.
- If the parameter is Normal
- If the parameter is Undefined or Malfunction
- Verify the scan tool Lane Departure Warning Switch Status parameter changes between Open and Closed when pressing and releasing the lane departure warning switch.
- If the parameter does not change between Open and Closed
Refer to Circuit/System Testing - Lane Departure Warning Switch Circuit Malfunction.
- If the parameter changes between Open and Closed
- If the parameter does not change between Open and Closed
- Verify the lane departure warning indicator turns ON and OFF when turning the lane departure warning system on and off with the lane departure warning switch.
- If the indicator does not turn ON and OFF
Refer to Circuit/System Testing - Lane Departure Warning Switch Indicator Circuit Malfunction.
- If the indictor turns ON and OFF
- If the indicator does not turn ON and OFF
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.