Audio System Transceiver Module Replacement (U42)

2016 GMC Acadia SLT, FWDSECTION Audio System Transceiver Module Replacement (U42)
Fig 1: View Of Audio System Transceiver Module (U42)
GM1746253Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the video display assembly. Refer to Video Display Replacement (U42) .
1 Roof Console Assembly
Refer to Roof Rear Console Replacement (With RPO C3U)Roof Rear Console Replacement (Without RPO C3U) .
2 Audio System Transceiver Module Assembly

Procedure

  1. Disconnect the electrical connector.
  2. Use a flat bladed tool to release the tabs that secure the module to the roof console on each side of the module.
  3. Slide forward and up to release from the roof console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.