Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- With the regulator in the remove/load position, install the window (1) to the door.
- Tilt the window forward and carefully guide the window into the rear channel.
- Position the window to an upright position. Ensure that the window is seated into the channels.
- Position the window (1) to a fully secure position into the upper door weatherstrip.
- Install the rear door window regulator. Refer to Rear Side Door Window Regulator Replacement .
Do not operate the regulator motor without supporting the window. Ensure that the window remains in the channels when operating the regulator motor.
Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the channels.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.