Symptom Related Diagnostic Procedures

2013 GMC Yukon 4WD V8-6.0L HybridSECTION Symptom Related Diagnostic Procedures



Symptoms - Hybrid Energy Storage

Important:
The following steps must be completed before using the symptom tables.


1. Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle before using the symptom tables in order to verify that all of the following are true:

* There are no DTCs set.

* The control modules can communicate via the serial data link.

2. Review the system operation in order to familiarize yourself with the system functions.

Refer to the following procedures:

* Drive Motor Battery Cooling Description Drive Motor Battery Cooling Description.

* Drive Motor Battery High Voltage Contactor Relay Operation Drive Motor Battery High Voltage Contactor Relay Operation.

Visual/Physical Inspection

* Inspect for aftermarket devices which could affect the operation of the HVAC System. Refer to Checking Aftermarket Accessories Checking Aftermarket Accessories.

* Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom.

* Blocked or restricted hydrogen battery vent tube may cause drive motor battery odor.

* Inspect the air distribution system for blocked or damaged air inlet or outlet ducts, which cause reduced air flow.

Intermittent

Faulty electrical connections or wiring may be the cause of intermittent conditions. Refer to Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections.

Symptom List

Refer to a symptom diagnostic procedure from the following list in order to diagnose the symptom:

* Drive Motor Battery Odor Drive Motor Battery Odor

* Drive Motor Battery Noise Drive Motor Battery Noise

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.