SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA H1500, VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKWIRING SYSTEMS AND POWER MANAGEMENT - DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC INFORMATION AND PROCEDURESREPAIRING CONNECTOR TERMINALS (TERMINAL REPAIR)CABLE SEAL TERMINALS
2013 GMC Savana H1500, Van Passenger

Cable Seal Terminals

2013 GMC Savana H1500, Van PassengerSECTION Cable Seal Terminals
  1. Cut off the terminal between the core and the insulation crimp to minimize any wire loss.
  2. Remove the old seal.
  3. Apply the correct cable seal, per the wire gauge size, from the kit. Slide the seal back along the wire to enable removal of the insulation.
  4. To minimize wire loss, remove only the insulation required.
  5. Using the connector end view, determine the correct crimp tool and crimp jaw.
  6. Align the seal with the end of the cable insulation.
  7. Position the stripped wire and seal in the terminal.
  8. Hand Crimp the core wings first.
  9. Hand Crimp the insulation wings around the seal and the cable.
  10. Solder all of the hand crimp terminals except the Micro-Pack 100 and 0.64 sizes.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.