Power Steering Pump Replacement (LGH)

2013 GMC Savana H1500, Van CargoSECTION Power Steering Pump Replacement (LGH)
Fig 1: Power Steering Pump (LGH)
GM2375509Courtesy of GENERAL MOTORS COMPANY
Power Steering Pump Replacement (LGH)

Callout Component Name

Preliminary Procedures

  1. Place drain pans under the vehicle.
  2. Remove as much power steering fluid from the reservoir as possible.
  3. Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (6.6L)Β .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left front wheelhouse splash shield. Refer to Wheelhouse Splash Shield Replacement .
1 Power Steering Fluid Cooler Hose Clamp
2 Power Steering Fluid Cooler Hose
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.