SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA H1500, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKIMMOBILIZER SYSTEMREPAIR INSTRUCTIONSTHEFT DETERRENT MODULE REPLACEMENT
2013 GMC Savana H1500, Van Cargo

Theft Deterrent Module Replacement

2013 GMC Savana H1500, Van CargoSECTION Theft Deterrent Module Replacement
Fig 1: View Of Theft Deterrent Module Assembly
GM1699383Courtesy of GENERAL MOTORS COMPANY
Theft Deterrent Module Replacement

Callout Component Name

Preliminary Procedure

  1. Disable the SIR. Refer to SIR Disabling and Enabling .
  2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
1 Theft Deterrent Module Assembly

Procedure

  1. Pull the theft deterrent module out away from lock cylinder case and disconnect the electrical connector.
  2. Refer to Control Module References for programing and setup of the theft deterrent control module after replacement..
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.