Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2013SAVANA H1500, VAN CARGOREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESSTEERING WHEEL AND STEERING COLUMNREPAIR INSTRUCTIONSTURN SIGNAL MULTIFUNCTION SWITCH REPLACEMENTINSTALLATION PROCEDURE
2013 GMC Savana H1500, Van Cargo
Installation Procedure
2013 GMC Savana H1500, Van CargoSECTION Installation Procedure
- Install the turn signal and multifunction switch assembly (2) to the steering column tilt head assembly.
- Install the 2 screws (1) to the turn signal and multifunction assembly and tighten to 3 N.m (27 lb in).
- Connect the turn signal and multifunction switch assembly connector.
- Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.