Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2013 GMC RV Cutaway 4.8L Eng VIN ASECTION Installation Procedure
- Install the heater assembly.
- Connect the vacuum lines to the actuators.
- Connect the temperature actuator electrical connector.
- Install the I/P carrier. Refer to Instrument Panel Carrier Replacement .
- Install the heater assembly retaining nuts (2) to the engine compartment and tighten to 6 N.m (53 lb in).
- Install the evaporator and blower module assembly. Refer to Air Conditioning (A/C) Evaporator and Blower Module Assembly Replacement .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.