Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON XL 4WD V8-6.0LREPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFSERVICE AND REPAIR
2011 GMC Yukon XL 4WD V8-6.0L
Sunroof / Moonroof: Service and Repair
2011 GMC Yukon XL 4WD V8-6.0LSECTION Service and Repair
Sunroof Module Bracket Replacement
Removal Procedure
1. Remove the overhead console. Refer to Roof Console Replacement Roof Console Replacement.
2. Remove one left side screw from the bracket.
3. Carefully pulling down on the front edge of the headliner, swing the bracket downward to release the right side from the module.
Installation Procedure
Caution: Refer to Fastener Caution Fastener Caution.
1. Install the screw to the bracket.
Tighten the screw to 2 Nm (18 lb in)
2. Install the overhead console. Refer to Roof Console Replacement Roof Console Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.