Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2011YUKON HYBRID, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDATA COMMUNICATIONS SYSTEMREPAIR INSTRUCTIONSSERIAL DATA GATEWAY MODULE REPLACEMENT (HP2)

2011 GMC Yukon Hybrid, 4WD

Serial Data Gateway Module Replacement (HP2)

2011 GMC Yukon Hybrid, 4WDSECTION Serial Data Gateway Module Replacement (HP2)

Fig 1: Serial Data Gateway Module

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures
Remove the inflatable restraint module. Refer to Instrument Panel Inflatable Restraint Module Replacement .

Serial Data Gateway Module Assembly

Procedure

Press on the tabs to release the serial data gateway module.
Disconnect the electrical connectors.
Reprogram the serial data gateway module if replaced. Refer to Control Module References .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.