SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON HYBRID, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE REPLACEMENT (CADILLAC)
2011 GMC Yukon Hybrid, 4WD

Communication Interface Module Replacement (Cadillac)

2011 GMC Yukon Hybrid, 4WDSECTION Communication Interface Module Replacement (Cadillac)
Fig 1: Communication Interface Module
GM1816302Courtesy of GENERAL MOTORS CORP.
Communication Interface Module Replacement (Cadillac)

Callout Component Name

Preliminary Procedure

  1. Remove the instrument Panel Accessory Trim Plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Except Cadillac) , Instrument Panel Accessory Trim Plate Replacement (Cadillac) .
  2. Remove the radio. Refer to Radio Replacement (Except Cadillac) , Radio Replacement (Cadillac) .
  3. Remove the HVAC Control Module. Refer to HVAC Control Module Replacement , or HVAC Control Module Replacement .
1 Communication Interface Module
  • Push outward on the two tabs to release the communication interface module from the bracket.
  • Disconnect the electrical connectors.
  • When replacing the communication interface module be sure to transfer Bluetooth Antenna, if equipped.
  • Reprogram the communication interface module after replacement. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.