SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSFRONT SIDE DOOR OUTSIDE HANDLE REPLACEMENT
2011 GMC Yukon Base, 5.3 0, RWD

Front Side Door Outside Handle Replacement

2011 GMC Yukon Base, 5.3 0, RWDSECTION Front Side Door Outside Handle Replacement
Fig 1: Front Side Door Outside Handle
GM1673305Courtesy of GENERAL MOTORS CORP.
Front Side Door Outside Handle Replacement

Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Lock Rod Retaining Clip

Procedure

  1. Remove the rubber grommet to access the bolts.
  2. Plug in the window switch and raise the window.
  3. Release the handle lock rod from the door lock.
  4. Release the door handle lock cylinder rod.
2 Front Side Door Outside Handle Lock Rod
3 Front Side Door Outside Handle Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
8 N.m (71 lb in)
4 Front Side Door Outside Handle

Procedure

  1. Transfer the handle lock rod to the new handle.
  2. In order to prevent outside handle lever pre-load, latch, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral latch clip to outside handle rod. Integral latch clip shall be in the full up position while securing to outside handle rod.

TIP:  Inspect the door for proper operation before installing the trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.