SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSFRONT SIDE DOOR LOCK REPLACEMENT
2011 GMC Yukon Base, 5.3 0, RWD

Front Side Door Lock Replacement

2011 GMC Yukon Base, 5.3 0, RWDSECTION Front Side Door Lock Replacement
Fig 1: Front Side Door Lock
GM1673309Courtesy of GENERAL MOTORS CORP.
Front Side Door Lock Replacement

Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Inside Door Handle Cable Retainer Clip
2 Front Side Door Lock Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

  1. Release the door lock cylinder rod.
  2. Release the outside door handle rod from the door lock clip.
  3. The mandatory sequence is 3, 1, 2.

Tighten 
10 N.m (89 lb in)
3 Front Side Door Lock
  1. Disconnect the electrical plug.
  2. Transfer all parts to the new lock.
  3. It may be necessary to reprogrammed the door lock module after replacing the lock. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.