Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B396FCOMPONENT TESTING
2011 GMC Yukon Base, 5.3 0, RWD
Component Testing
2011 GMC Yukon Base, 5.3 0, RWDSECTION Component Testing
- Ignition OFF, disconnect the harness connector at the liftglass latch assembly.
- Test for infinite resistance between the signal terminal 4 and the ground terminal 3 with the switch in the open position.
- If not the specified value, replace the liftglass latch assembly.
- Test for less than 2 Ξ© between the signal terminal 4 and the ground terminal 3 with the switch in the closed position.
- If not the specified value, replace the liftglass latch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.