Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2495CIRCUIT/SYSTEM VERIFICATION
2011 GMC Yukon Base, 5.3 0, RWD
Circuit/System Verification
2011 GMC Yukon Base, 5.3 0, RWDSECTION Circuit/System Verification
- Ignition OFF, transmission in Park, using either the power door lock switches or the remote keyless entry transmitter, LOCK all doors and then UNLOCK all doors. This will set the liftgate module door lock status to unlock.
- Manually open the liftgate, the liftgate latch assembly should release allowing the liftgate to be pulled open
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.