SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MODE ACTUATOR THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSSEAT ADJUSTER SWITCH - DRIVER (AN3)
2011 GMC Yukon Base, 5.3 0, RWD

Seat Adjuster Switch - Driver (AN3)

2011 GMC Yukon Base, 5.3 0, RWDSECTION Seat Adjuster Switch - Driver (AN3)
Fig 1: Seat Adjuster Switch - Driver (AN3) Connector End View
GM623046Courtesy of GENERAL MOTORS CORP.
Seat Adjuster Switch - Driver (AN3)

Pin Wire Circuit Function
A 0.35 D-GN 1518 Front Vertical Up Switch Signal
B - - Not Used
C 0.35 L-GN 1523 Horizontal Rearward Switch Signal
D 0.35 TN 1522 Horizontal Forward Switch Signal
E 0.35 PU/WH 6205 Battery Positive Voltage
F 0.35 YE 1519 Rear Vertical Up Switch Signal
G 0.35 D-GN/WH 1270 Recline Rearward Switch Signal
H 0.35 GY/BK 1269 Recline Forward Switch Signal
J 0.35 L-BU 1521 Rear Vertical Down Switch Signal
K 0.35 D-BU 1520 Front Vertical Down Switch Signal
Connector Part Information
  • Harness Type: Driver Seat
  • OEM Connector: 15326931
  • Service Connector: 15306309
  • Description: 10-Way F GT 280 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575753
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 15304711/8
  • Core/Insulation Crimp: E/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.