SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MODE ACTUATOR THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSRADIO X3 (U42)
2011 GMC Yukon Base, 5.3 0, RWD

Radio X3 (U42)

2011 GMC Yukon Base, 5.3 0, RWDSECTION Radio X3 (U42)
Fig 1: Radio X3 (U42) Connector End View
GM2133386Courtesy of GENERAL MOTORS CORP.
Radio X3 (U42)

Pin Wire Circuit Function
1 0.35 YE 2059 Auxiliary Audio Left Signal
2 0.35 WH 2058 Auxiliary Audio Right Signal
3 0.35 L-BU 5826 Left DVD Audio Signal (+)
4 0.35 WH 5828 Right DVD Audio Signal (+)
5 0.35 OG/BK 5831 Remote Infra Red Signal (+)
6 0.35 PK/BK 5844 Video Bright Control
7 0.35 D-GN 6975 DVD Video Signal (+)
8 0.35 PU 2056 Auxiliary Video High Signal
9 0.35 BARE 5345 Drain Wire
10 0.35 L-GN/BK 5845 Video Module Signal
11 0.35 PU 6979 DVD Audio Common
12 0.35 BARE 6980 DVD Audio Shield
13 0.35 TN/WH 5830 Remote Infra Red Signal (-)
14 0.35 BARE 6976 DVD Video Drain Wire
15 0.35 WH/BK 5335 DVD Video Signal (-)
16 0.35 BARE 5346 Video Drain Wire
Connector Part Information
  • Harness Type: Instrument Panel (STZ or Y91)
  • Harness Type: Instrument Panel Extension (without STZ or Y91)
  • OEM Connector: 13568239 (STZ or Y91)
  • OEM Connector: 13783350 (without STZ or Y91)
  • Service Connector: 13504589 (STZ or Y91)
  • Service Connector: 13580577 (without STZ or Y91)
  • Description: 16-Way F Micro 64 Series, Sealed (GY)
Terminal Part Information
  • Terminated Lead: 13575535
  • Release Tool: J-38125-21
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: 15359541/4
  • Core/Insulation Crimp: M/M
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.