SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSELECTRONIC POWER STEERING MOTOR CONTROL MODULE X3 (HP2)
2011 GMC Yukon Base, 5.3 0, RWD

Electronic Power Steering Motor Control Module X3 (HP2)

2011 GMC Yukon Base, 5.3 0, RWDSECTION Electronic Power Steering Motor Control Module X3 (HP2)
Fig 1: Electronic Power Steering Motor Control Module X3 (HP2) Connector End View
GM2042481Courtesy of GENERAL MOTORS CORP.
Electronic Power Steering Motor Control Module X3 (HP2)

Pin Wire Circuit Function
1 L-GN - Low Reference
2 YE - Drain Wire
3 BK - 5-Volt Reference
4 L-GN - 5-Volt Reference
5 BK - Drain Wire
6 BK - Low Reference
7 WH - Motor Resolver SIN
8 RD - Motor Resolver COS
9 WH - Low Reference
10 RD - Torque Sensor Input Shaft SIN
11 BN - Torque Sensor Input Shaft COS
12 YE - Torque Sensor Output Shaft SIN
13 BU - Torque Sensor Output Shaft COS
Connector Part Information
  • Harness Type: Steering Gear Sensor Harness
  • OEM Connector: 6189-1092
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 13-Way F TS Series, Sealed (GY)
Terminal Part Information
  • Terminal/Tray: 8100-3456/26
  • Core/Insulation Crimp: K/K
  • Release Tool/Test Probe: 15315247/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.