SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011YUKON BASE, 5.3 0, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSREAR SIDE DOOR OUTSIDE HANDLE REPLACEMENT
2011 GMC Yukon Base, 5.3 0, RWD

Rear Side Door Outside Handle Replacement

2011 GMC Yukon Base, 5.3 0, RWDSECTION Rear Side Door Outside Handle Replacement
Fig 1: Rear Side Door Outside Handle (Crew Cab)
GM1673310Courtesy of GENERAL MOTORS CORP.
Rear Side Door Outside Handle Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
1 Rear Side Door Outside Handle Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .

  1. Release the outside handle rod from the lock retainer clip.
  2. Release the lock cylinder rod from the door lock.
  3. Remove to outside door handle with the rod attached.

Tighten 
8 N.m (71 lb in)
2 Rear Side Door Outside Handle
TIP:  Transfer the handle rod to the new handle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.