Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE CONTROLS AND FUEL - 6.6L (LGH) - DTC P0016 THROUGH DTC P11DC)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0640TESTINGCIRCUIT/SYSTEM TESTING
2011 GMC Savana Special 4.8 A
Circuit/System Testing
2011 GMC Savana Special 4.8 ASECTION Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
NOTE:
You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
- Ignition OFF, disconnect the harness connector at the E24 intake air heater.
- Ignition ON, test for less than 2 V between the Intake Air Heater Switch On/Off Signal circuit terminal 2 and ground.
- If greater than the specified value, test the Intake Air Heater Switch On/Off Signal circuit for a short to voltage. If the circuit tests normal, replace the K34 glow plug control module.
- If less than the specified value, replace the E24 intake air heater.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.