SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENT
2011 GMC Savana Special 4.8 A

Tail Lamp Replacement

2011 GMC Savana Special 4.8 ASECTION Tail Lamp Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Tail Lamp
GM1892830Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the back body side opening applique. Refer to Back Body Opening Side Applique and Tail Lamp Replacement .
1 Tail Lamp Nut (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:  5 N.m (44 lb in)
2 Tail Lamp Electrical Connector

Procedure

  1. Pull the lamp assembly rearward.
  2. Release the electrical harness rubber grommet.
  3. Disconnect the electrical connector from the rearward lamp harness.
3 Tail Lamp Assembly
Tip:  Remove the bulb sockets and service the bulbs as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.