Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 19 (FIXED AND MOVEABLE WINDOWS SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2011 GMC Savana Special 4.8 A
Fastener Tightening Specifications
2011 GMC Savana Special 4.8 ASECTION Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specifications | |
|---|---|---|
| Metric | English | |
| Bodyside Window Hinge Nuts | 10 N.m | 89 lb in |
| Bodyside Window Latch Screws | 3 N.m | 27 lb in |
| Front Door Window Nuts | 11 N.m | 97 lb in |
| Front Door Window Run Channel Bolts | 11 N.m | 97 lb in |
| Front Door Window to Sash Nuts | 11 N.m | 97 lb in |
| Power Window Motor to Front Door Module | 11 N.m | 97 lb in |
| Rear Door Run Channel Bolts | 11 N.m | 97 lb in |
| Rear Window Hinge Screws | 3 N.m | 27 lb in |
| Rear Window Latch Screws | 3 N.m | 27 lb in |
| Windshield Side Reveal Molding Screw | 8 N.m | 71 lb in |
| Windshield Weatherstrip Screw along the Inside Edge of the Windshield Frame | 2.5 N.m | 22 lb in |
| Windshield Weatherstrip Screw to the Upper Corner of the Windshield Pillar | 2.5 N.m | 22 lb in |
| Windshield Weatherstrip Side Retainer Screws | 3 N.m | 27 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.