Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Assembly Procedure
2011 GMC Savana Special 4.8 ASECTION Assembly Procedure
WARNING: This page is about a different car, the 2011 GMC Savana and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure the flow control spring (5) does not fall out of the pump housing (1).
- Lubricate the NEW O-ring seal (3) with power steering fluid.
- Install the O-ring seal onto the connector and fitting assembly (2).
- Install the control valve assembly (4).
- Install the connector and fitting assembly (2) and tighten to 62 N.m (46 lb ft).
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.