SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 176 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - FUEL INJECTOR 6 THROUGH YAW SENSOR)COMPONENT CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) X2 (UE1)
2011 GMC Savana Special 4.8 A

Vehicle Communication Interface Module (VCIM) X2 (UE1)

2011 GMC Savana Special 4.8 ASECTION Vehicle Communication Interface Module (VCIM) X2 (UE1)
WARNING: This page is about a different car, the 2011 GMC Savana, 2011 Chevrolet RV Cutaway, 2011 Chevrolet Cutaway, and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Connector End View Vehicle Communication Interface Module (VCIM) X2 (UE1)
GM1471691Courtesy of GENERAL MOTORS CORP.
Vehicle Communication Interface Module (VCIM) X2 (UE1)

Pin Wire Circuit Function
1 0.8 D-BU 658 Cellular Telephone Voice Signal
2 0.8 L-BU/BK 659 Low Reference
3 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus (+)
4 0.5 TN 2501 High Speed GMLAN Serial Data Bus (-)
5-7 - - Not Used
8 0.5 BARE 1792 Drain Wire
9 0.8 GY 655 Cellular Telephone Voice Signal
10 0.8 D-GN 654 Low Reference
11-12 - - Not Used
Connector Part Information
  • Harness: Instrument Panel
  • OEM: 15431365
  • Service: 88952886
  • Description: 12-Way F Micro-Pack 100A Series (NA)
Terminal Part Information
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: Pins: 3-4, 8 - J/J
  • Core/Insulation Crimp: Pins: 1-2, 9-10 - K/K
  • Release Tool/Test Probe: J-38125-559/J-35616-16 (L-GN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.