SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 176 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - FUEL INJECTOR 6 THROUGH YAW SENSOR)COMPONENT CONNECTOR END VIEWSHVAC CONTROL ASSEMBLY X2
2011 GMC Savana Special 4.8 A

HVAC Control Assembly X2

2011 GMC Savana Special 4.8 ASECTION HVAC Control Assembly X2
WARNING: This page is about a different car, the 2011 GMC Savana, 2011 Chevrolet RV Cutaway, 2011 Chevrolet Cutaway, and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Connector End View HVAC Control Assembly X2
GM62469Courtesy of GENERAL MOTORS CORP.
HVAC Control Assembly X2

Pin Wire Circuit Function
A 0.8 YE 60 Blower Motor Low Control
B 0.8 TN 63 Blower Motor Medium Control
C 0.8 L-BU 72 Medium 2 Blower Motor Control
D 0.8 OG 52 Blower Motor High Control
E 1 BN 141 Ignition Voltage
F 0.8 L-BU 733 Air Temperature Door Control
G 1 WH 119 Blower Motor Switch Control
H 0.5 D-GN/WH 762 A/C Request Signal (C60)
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 12064998
  • Service Connector: 15306189
  • Description: 8-Way F Metri-Pack 280 Series (BK)
Terminal Part Information
  • Pins: A-G
  • Terminated Lead: Pending
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 12066214/2
  • Core/Insulation Crimp: Pins: A-D, F- Not Available
  • Core/Insulation Crimp: Pins: E, G- F/D
  • Pin H
  • Terminated Lead: Pending
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 12034046/2
  • Core/Insulation Crimp: E/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.